Shindaiwa EB8520RT Manual del operador descargar pdf (Pagina 20)

Engine operation

Engine warm-up

1. Once the engine starts, return throttle position lever forward

(idle), allow it to warm up for 2 to 3 minutes at idling (i.e. low

speed).

2. Warming the engine helps to lubricate its internal workings

more smoothly. Allow the engine to warm up fully, especially

when it is cold.

3. Never run the engine without the blower pipes fitted.

Starting a warm engine

 The starting procedure is the same as Cold Start except DO

NOT close the choke.

1. Ignition Switch

Move ignition switch to "I" (START) position.

2. Throttle Position Lever

Move throttle position lever midway between idle and full

throttle positions.

3. Purge Bulb

Pump purge bulb until fuel is visible and flows freely in the

clear fuel tank return line.

4. Recoil Starter

Place the blower on a flat, clear area. Hold the blower firmly

with left hand and rapidly pull recoil starter handle/rope until

engine fires.

Stopping the engine

1. Throttle Position Lever

Release throttle trigger. Move throttle position lever forward

to idle position and allow engine to return to idle before shut-

ting off engine.

2. Move ignition switch to "O" (STOP) position.

1. Ignition switch 2. Throttle position lever

1. Purge bulb

1. Starter handle

NOTE

If engine does not start after 5 pulls, use cold start procedures.

1. Ignition switch

3. Throttle trigger

2. Throttle position lever

WARNING

If engine does not stop when ignition switch is moved to

STOP position, close choke - position - to stall engine.

Have your shindaiwa dealer repair ignition switch before

using blower again.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 135 136

Comentarios a estos manuales

Sin comentarios

Shindaiwa EB8520RT Manual del operador Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Motor Shindaiwa EB8520RT